Conforming to all major international rebar standards and produced under quality control system ISO9001 : 2008.
The Terex^® bars unique threadlike deformation for multipurpose application can be cut at any length and spliced
with the Terex^® coupler with minimal preparation without reducing the capacity of the bar.

The Terex^® thread-like deformations, rolled as a typical rebar may be prepared by eliminating the longitudinal ribs
at the end of the bar over a desired length leaving a highly durable coarse thread.

The elimination of longitudinal ribs can be performed with a small hand held hydraulic press, applied until the required
length of thread has been achieved. The Terex^® bar offers all the advantages of a fully threaded bar at the cost of a
reinforcing bar. Ideal for heavy construction and geotechnical application.

Concrete Reinforcement Steel Bars
Rock Bolts
Mini and Micro Piles
Piles and Diaphragm Wall Cages
Ground Anchors
Soil Nails
Tie Rods

The data contained herein is considered representative of our current production but we reserve the right to make changes and improvements to the products and/or the process which may result in benefit and/or changes to physical/mechanical characteristics.